TEST PROCEDURE
One reference measurement each with 100 ohm (±5%)
and 1 ohm (±5%) as a DUT substitute must be performed
and documented. Verification of the edge steepness must
be provided with this test setup. Low-inductance parts
must be used as resistors.
The load resistor must have the following characteristics
to achieve the required pulse parameters:
- Low Inductive Component
- Shortest possible cables (a few cm) to the PFM output
- Probe must be as near as possible to the load resistor or,
as with the CA LV 124-P, using a BNC connection directly
on the load.
